SKHJ-C horizontal flange correcting machine is mainly used for H beam welding and T-beam rear wing correction for correcting flange H beam production line, when the H-beam welding process is completed, the role of welding applications H-beam wing will be deformed, it must be calibrated before use.

SKHJ-C horizontal flange correcting machine consists of three parts as:

a, former rollers: total length 15000mm, width 3000mm, the main function of the front rollers is to correct the work conveying to the correct host.

b, Host: length 6500mm, width 2000mm, height 2800mm, Host by the left and right two separate flange straightening machine, the main function is the simultaneous correction of both sides of host H-beam flange.

c, rear table: Total length 15000mm, width 3000mm, the main feature is to correct roller good H-beam transfer out.

SKHJ-C horizontal flange correcting machine uses the overall structure of horizontal correction, the left flange straightening machine fixed, right side flange straightening machine can be corrected with web height changes in the road; and the use of dynamic roll mechanism vertical placement, which can make vertical, horizontal movement in both directions to accommodate changes in height H-beam center. Right side flange straightening machine can be moved in the horizontal direction of the rolling track, when the web height changes, on the right wing of the host can be done to correct the move. It correction power for the hydraulic system, the power line shift control of small ratio of mass balance using pin wheel reducer, to achieve a smooth low-speed transmission.